AC Repair
Refrigerant leaks, compressor faults, blower motors, fan motors, and control board failures on split and packaged systems.
Residential & light commercial HVAC
AC repair and heating service built around the equipment on your property.
Clear Path services central air conditioners, heat pumps, and furnaces across residential and small commercial systems. We diagnose the actual fault, explain the repair, and leave the equipment running the way it should.
Direct line: +1(619) 387-0804
24/7 dispatch
Sealed-system repair
Duct & coil service
Repair work for the parts that actually fail.
Most air conditioning calls start with a refrigerant charge issue, a dirty coil, a failing capacitor, or a blower motor that has drawn down. Heating problems usually trace back to a limit switch, an igniter, a heat exchanger, or airflow. We check the whole system before recommending a part so you are not paying for the wrong repair twice.
Service lines
Heating Service
Furnace diagnostics, igniters, limit switches, heat exchangers, gas valve checks, and heat pump heating circuits.
HVAC Maintenance
Tune-up visits covering coil cleaning, filter service, electrical connections, airflow checks, and drain line flushing.
Straight answers on equipment condition
Clear Path started as a two-truck repair outfit working mostly on split systems installed in the 90s and early 2000s. A lot of that equipment is still on roofs and in basements today, and it needs a technician who has seen the failure before.
We handle refrigerant recovery properly, keep the electrical work clean, and tell you when a component is near the end of its service life rather than selling a replacement unit by default.
- Residential and light commercial systems
- Split, packaged, and mini-split equipment
- Furnace and heat pump heating service
What makes up the system
Thermostat
Sets the call for cooling or heating and sends the signal to the indoor equipment.
Condenser
Outdoor unit that rejects heat and circulates refrigerant through the loop.
Indoor unit
Air handler or furnace that moves conditioned air into the building supply ducts.
Ductwork
Supply and return paths. Leaks and blocked runs cut airflow and raise energy use.
Coils
Evaporator and condenser coils. Restricted airflow across them causes icing and burnout.
Controls
Capacitors, relays, contactors, and boards that switch and protect the system.
Annual maintenance checklist
- Condenser coil cleaned and fins straightened
- Evaporator coil inspected for frost and dirt buildup
- Filter replaced and filter rack cleared
- Blower motor and capacitor tested under load
- Refrigerant charge verified with proper gauges
- Condensate drain line flushed and checked
- Electrical connections tightened and amp draw measured
- Thermostat schedule and mode operation verified
Describe the problem and we will schedule service.
Tell us the system type, what the equipment is doing, and where the outdoor unit sits. That shortens the diagnosis and often means a single visit is enough.
1400 E Palomar St , Chula Vista, CA 91913
Call the service line
+1(619) 387-0804